Subject	Driveshaft removal tips/tricks?
Posted by	LJZTT on August 08, 2008 at 7:17 PM
	This message has been viewed 308 times.
Message	Folks, I am in the middle of trying to install the Energy Suspension Master Kit (aka The Super Happy Fun kit), and I have hit a bump in the road. I can't drop my subframe because I can't seem to get the allen head bolts to budge on the driveshaft flange at the rear differential. I shot them up good with Liquid Wrench before calling it a day, other than that, any suggestions? I have the parking brake set, trans in 2nd gear, and have been using a breaker bar, but the bolts don't budge, the axle just ends up turning if I crank on it too hard. There's got to be a better/smarter way to do this, no? The MANtage....be a real man search said you suck (n/m) - Wilks. 01:38:02 09/06/06
Follow Ups	Driveshaft removal tips/tricks? - LJZTT 19:17:38 08/08/08 Heat, the little propane bottle/torch works great (n/m) - 550HPTT 19:40:55 08/08/08 Open flame not permitted in the base auto shop (n/m) - LJZTT 22:26:58 08/08/08 Get a small hammer, tap on the heads of the bolts for a bit (n/m) - 550HPTT 09:21:27 08/09/08 straight on, or from the side? (n/m) - LJZTT 10:48:09 08/09/08 yes hit them straigth on from the head, if you have a - 550HPTT 11:00:55 08/09/08 Re: yes hit them straigth on from the head, if you have a - 550HPTT 11:26:11 08/09/08 came right off, soaked overnight with Liquid Wrench and - LJZTT 14:40:53 08/10/08 It was a trick my Grandfather taught me, does work well :) (n/m) - 550HPTT 12:40:59 08/12/08
Post a Followup	You cannot reply to this message because you are not logged in.