Subject	Try this...
Posted by	WoodmanZ on July 31, 2008 at 10:06 PM
	This message has been viewed 160 times.
In Reply To	crank pulley removal-engine in car posted by LADY_Z on July 31, 2008 at 09:50 PM
Message	Spray the bolt with pb blaster and allow it to sit and soak for a while. Afterwards hold the breaker bar up against the subframe, and have someone get in the car and just "bump" the ignition. It may take a couple bumps, but be sure that they do not hold the key, just enough to turn the crank a little. Usually will free the bolt every time.
Follow Ups	crank pulley removal-engine in car - LADY_Z 21:50:42 07/31/08 put it in 5th gear (n/m) - aliaZ 21:52:37 07/31/08 Try this... - WoodmanZ 22:06:36 07/31/08 thanks - LADY_Z 22:29:24 07/31/08 You'll also need a good pulley puller to get the pulley - WoodmanZ 12:49:16 08/01/08 2nd - but use caution when doing this and stay safe... (n/m) - jzack 23:55:25 07/31/08 Put a piece of plywood between the pulley and the - zellamay 01:06:55 08/01/08 The e-brake won't stop it. Have someone sit in the car - Audioquest 11:11:37 08/01/08 if it is in 5th gear the e-brake will hold fine - aliaZ 14:59:35 08/01/08 Re: crank pulley removal-engine in car - turbo1 15:07:59 08/01/08 5th gear and utilize a breaker bar. Always works for me. (n/m) - Milo (SATX) 15:37:44 08/01/08 Re: crank pulley removal-engine in car - LADY_Z 18:29:29 08/03/08
Post a Followup	You cannot reply to this message because you are not logged in.