Subject	crank pulley removal-engine in car
Posted by	LADY_Z on July 31, 2008 at 9:50 PM
	This message has been viewed 265 times.
Message	Hi, I'm replacing the water pump, thermostat and timing belt on my NA Z, and i'm held up by not being able to get the crank pulley off. I've read some of the other topics on this, but, still no luck. I don't have air, but i do have a very big bar, tranny still attatched and lots of determination....any suggestions? I'm desperate! I had the car in reverse, e-brake on, wheels blocked and it still just moves the car....I'm not big on jamming the flywheel up with something but i will take ANY suggestions.- Thanks -BTW i still have the old timing belt on...everything is tight, just can't crack the bolt
Follow Ups	crank pulley removal-engine in car - LADY_Z 21:50:42 07/31/08 put it in 5th gear (n/m) - aliaZ 21:52:37 07/31/08 Try this... - WoodmanZ 22:06:36 07/31/08 thanks - LADY_Z 22:29:24 07/31/08 You'll also need a good pulley puller to get the pulley - WoodmanZ 12:49:16 08/01/08 2nd - but use caution when doing this and stay safe... (n/m) - jzack 23:55:25 07/31/08 Put a piece of plywood between the pulley and the - zellamay 01:06:55 08/01/08 The e-brake won't stop it. Have someone sit in the car - Audioquest 11:11:37 08/01/08 if it is in 5th gear the e-brake will hold fine - aliaZ 14:59:35 08/01/08 Re: crank pulley removal-engine in car - turbo1 15:07:59 08/01/08 5th gear and utilize a breaker bar. Always works for me. (n/m) - Milo (SATX) 15:37:44 08/01/08 Re: crank pulley removal-engine in car - LADY_Z 18:29:29 08/03/08
Post a Followup	You cannot reply to this message because you are not logged in.