Subject	still trying to narrow down some problems with car
Posted by	keffboyer2000 on June 02, 2008 at 9:53 PM
	This message has been viewed 127 times.
Message	well came across a few issues i would like to get some advice for. After testing the fuel injectors from the main harness and getting get ohm readings for all them. I decided to test some other pins like #23 detonation sensor, #26 and #27 Airflow meter, #25 Wastegate valve control, and #18 fuel pump relay. The Main concern would be that the detonation sensor inside the engine bay is clearly cut and not connected but i got no ecu code from the computer for this so someone said there might a resister connected somewhere along the line couldn't find anything. When i tested pin #23 Detonation sensor i got nothing. So My question is why would the ecu not show a code? Could the ecu be damaged?
Follow Ups	still trying to narrow down some problems with car - keffboyer2000 21:53:20 06/02/08 Anythings possible..you should have 2.5volts..so - twinturbineZ 22:40:06 06/02/08 what should be 2.5 volts? and would the car still run with a - keffboyer2000 16:47:31 06/03/08 Hello???? The Det sensor output from the ECU you asked about - twinturbineZ 17:03:10 06/03/08 i did do a ecu diagnostics all is fine. Changed the fuel fil - keffboyer2000 17:40:29 06/03/08 DETOATNION!!!!and Or........ - twinturbineZ 18:53:41 06/03/08 *Detonation* (n/m) - twinturbineZ 18:55:05 06/03/08
Post a Followup	You cannot reply to this message because you are not logged in.