Subject	If my half-moon ruber insulator has a thin metal plate
Posted by	Fly-Surf on June 01, 2008 at 6:06 AM
	This message has been viewed 119 times.
In Reply To	agreed. the corrosion issue that occurs with the older posted by robo (sebring1970) on May 31, 2008 at 11:53 PM
Message	If that got mis-aligned during installation, could that supress the pin on top...and cause the injector to not work right? Robo, In all your pictures (Dremel) the pin on top is "up" but on this injector the pin was recessed, so I might have a slight mis-alignmnet in the half-moon cap. If the pin is binding, is the injector ruined?
Follow Ups	Replacing injector connector...colors wires - Fly-Surf 18:11:54 05/31/08 Doesn't matter..it's a/c voltage (n/m) - twinturbineZ 18:19:46 05/31/08 Okay...on the relacement connector 1 wire is larger - Fly-Surf 18:22:06 05/31/08 Yes, thick to thick, thin to thin is the recommended way (n/m) - 300ZMang 18:34:58 05/31/08 Even if they are reversed from original to new.. - Fly-Surf 19:55:17 05/31/08 No, it doesn't matter. It will work either way. (n/m) - Woody75 (Denver) 22:15:50 06/01/08 Actually it's pulsed DC. (n/m) - jzack 23:27:51 05/31/08 you're correct (n/m) - twinturbineZ 23:37:49 05/31/08 agreed. the corrosion issue that occurs with the older - robo (sebring1970) 23:53:34 05/31/08 If my half-moon ruber insulator has a thin metal plate - Fly-Surf 06:06:36 06/01/08 I believethat's your problem (n/m) - twinturbineZ 15:34:03 06/01/08 To clarify...I believe if the pin is depressed the - twinturbineZ 17:06:13 06/01/08 I dunno. I have some serious knowledge gaps there. - robo (sebring1970) 21:09:11 06/01/08 The plate should be glue to the rubber isolator - when new - Bernie (NoVA) 17:40:38 06/03/08 Thanks...good point... - Fly-Surf 14:01:17 06/04/08 Sure. (n/m) - Bernie (NoVA) 23:10:56 06/04/08 I installed the 2nd injector :-) - Fly-Surf 09:39:19 06/05/08 I installed the 2nd injector :-) - Fly-Surf 09:52:19 06/05/08 Excellent. (n/m) - Bernie (NoVA) 23:03:56 06/05/08
Post a Followup	You cannot reply to this message because you are not logged in.