Subject	agreed. the corrosion issue that occurs with the older
Posted by	robo (sebring1970) on May 31, 2008 at 11:53 PM
	This message has been viewed 105 times.
In Reply To	Actually it's pulsed DC. (n/m) posted by jzack on May 31, 2008 at 11:27 PM
Message	NISMO 555cc injectors occurs at least in part because of the direct current. Electrolysis does not occur with alternating current. "Straight-line acceleration is probably the first aspect of automotive performance that any intelligent driver gets bored with." Peter Gregg "We owe a lot to the dragsters. They always break something, figure out a way to beef up the part and the benefit trickles down." Robo "Not everything that can be counted counts. Not everything that counts can be counted." Einstein "And now my friend, the first-a rule of Italian driving, [Franco rips off his rear-view mirror and throws it out of the car] what's-a behind me is not important." Raul Julia, playing Franco Bertollini while driving a Ferrari Daytona in the movie Gumball Rally
Follow Ups	Replacing injector connector...colors wires - Fly-Surf 18:11:54 05/31/08 Doesn't matter..it's a/c voltage (n/m) - twinturbineZ 18:19:46 05/31/08 Okay...on the relacement connector 1 wire is larger - Fly-Surf 18:22:06 05/31/08 Yes, thick to thick, thin to thin is the recommended way (n/m) - 300ZMang 18:34:58 05/31/08 Even if they are reversed from original to new.. - Fly-Surf 19:55:17 05/31/08 No, it doesn't matter. It will work either way. (n/m) - Woody75 (Denver) 22:15:50 06/01/08 Actually it's pulsed DC. (n/m) - jzack 23:27:51 05/31/08 you're correct (n/m) - twinturbineZ 23:37:49 05/31/08 agreed. the corrosion issue that occurs with the older - robo (sebring1970) 23:53:34 05/31/08 If my half-moon ruber insulator has a thin metal plate - Fly-Surf 06:06:36 06/01/08 I believethat's your problem (n/m) - twinturbineZ 15:34:03 06/01/08 To clarify...I believe if the pin is depressed the - twinturbineZ 17:06:13 06/01/08 I dunno. I have some serious knowledge gaps there. - robo (sebring1970) 21:09:11 06/01/08 The plate should be glue to the rubber isolator - when new - Bernie (NoVA) 17:40:38 06/03/08 Thanks...good point... - Fly-Surf 14:01:17 06/04/08 Sure. (n/m) - Bernie (NoVA) 23:10:56 06/04/08 I installed the 2nd injector :-) - Fly-Surf 09:39:19 06/05/08 I installed the 2nd injector :-) - Fly-Surf 09:52:19 06/05/08 Excellent. (n/m) - Bernie (NoVA) 23:03:56 06/05/08
Post a Followup	You cannot reply to this message because you are not logged in.