Subject	Even if they are reversed from original to new..
Posted by	Fly-Surf on May 31, 2008 at 7:55 PM
	This message has been viewed 136 times.
In Reply To	Yes, thick to thick, thin to thin is the recommended way (n/m) posted by 300ZMang on May 31, 2008 at 06:34 PM
Message	Original and new connectors are opposite. Do injectors have "polarity"?
Follow Ups	Replacing injector connector...colors wires - Fly-Surf 18:11:54 05/31/08 Doesn't matter..it's a/c voltage (n/m) - twinturbineZ 18:19:46 05/31/08 Okay...on the relacement connector 1 wire is larger - Fly-Surf 18:22:06 05/31/08 Yes, thick to thick, thin to thin is the recommended way (n/m) - 300ZMang 18:34:58 05/31/08 Even if they are reversed from original to new.. - Fly-Surf 19:55:17 05/31/08 No, it doesn't matter. It will work either way. (n/m) - Woody75 (Denver) 22:15:50 06/01/08 Actually it's pulsed DC. (n/m) - jzack 23:27:51 05/31/08 you're correct (n/m) - twinturbineZ 23:37:49 05/31/08 agreed. the corrosion issue that occurs with the older - robo (sebring1970) 23:53:34 05/31/08 If my half-moon ruber insulator has a thin metal plate - Fly-Surf 06:06:36 06/01/08 I believethat's your problem (n/m) - twinturbineZ 15:34:03 06/01/08 To clarify...I believe if the pin is depressed the - twinturbineZ 17:06:13 06/01/08 I dunno. I have some serious knowledge gaps there. - robo (sebring1970) 21:09:11 06/01/08 The plate should be glue to the rubber isolator - when new - Bernie (NoVA) 17:40:38 06/03/08 Thanks...good point... - Fly-Surf 14:01:17 06/04/08 Sure. (n/m) - Bernie (NoVA) 23:10:56 06/04/08 I installed the 2nd injector :-) - Fly-Surf 09:39:19 06/05/08 I installed the 2nd injector :-) - Fly-Surf 09:52:19 06/05/08 Excellent. (n/m) - Bernie (NoVA) 23:03:56 06/05/08
Post a Followup	You cannot reply to this message because you are not logged in.