TwinTurbo.NET: Nissan 300ZX forum - You must of never attempted to pull the heads
Subject
You must of never attempted to pull the heads
Posted by
RedTTZ91(OK)
on May 28, 2008 at 12:07 AM
This message has been viewed
123
times.
In Reply To
Re: Know any reason you can't pull a short block out?
posted by WazTTed
on May 27, 2008 at 10:09 PM
Message
on a z. Go for it. I guarantee by the time your done you engine will be pulled out...with the heads attached
Follow Ups
Know any reason you can't pull a short block out?
-
yobobrox
19:37:50 05/27/08
No reason at all, if that is what you want to do, it
-
Fast300
19:58:17 05/27/08
What's the reason? Wouldn't it be a lot less labor
-
Audioquest
21:08:04 05/27/08
Well, if you're replacing the short block...
-
yobobrox
10:39:45 05/28/08
What is the shop doing for you? (n/m)
-
BigTDogg (MA)
13:58:35 05/28/08
See below. (n/m)
-
yobobrox
14:35:20 05/30/08
Re: Know any reason you can't pull a short block out?
-
WazTTed
22:09:30 05/27/08
You must of never attempted to pull the heads -
RedTTZ91(OK)
00:07:53 05/28/08
The point is its alot easier to
-
RedTTZ91(OK)
11:08:23 05/28/08
Did you read my follow-up?
-
yobobrox
11:23:10 05/28/08
And if not the heads, what about pulling the plenum off?
-
yobobrox
11:23:52 05/28/08
If you yourself can do so much as remove heads
-
RedTTZ91(OK)
17:35:48 05/28/08
Actually, I am doing the work myself.
-
yobobrox
14:35:00 05/30/08
Post a
Followup
You cannot reply to this message because you are not
logged in
.