Subject	Here ya go...
Posted by	ThunderZ on May 27, 2008 at 9:01 PM
	This message has been viewed 238 times.
In Reply To	After, the 555 are not in the engine yet, I have the oem posted by Turbonium 300Zx on May 27, 2008 at 08:46 PM
Message	dual MAF/dual POP/JWT dual POP ECU program: sensor no. IN=2 OUT=2 sensor cal. IN=2 OUT=AVE dual MAF/dual POP/single POP ECU program (stock or JWT,ASHTECH ETC): sensor no. IN=2 OUT=2 sensor cal. IN=2 OUT=ADD If you have a single mas, sensor cal. IN=1 You should not have to make any adjustments to the mixture for the Z to idle. You might have the wiring messed up.
Follow Ups	Anybody here know the settings on the Apexi neo AFC? - Turbonium 300Zx 18:54:59 05/27/08 Did this happen after you installed the AFC or after - ThunderZ 20:39:32 05/27/08 After, the 555 are not in the engine yet, I have the oem - Turbonium 300Zx 20:46:08 05/27/08 Here ya go... - ThunderZ 21:01:28 05/27/08 Thank you sir! (n/m) - Turbonium 300Zx 21:34:32 05/27/08 ThunderZ do you have specific setting configurations - jschrauwen 14:41:12 05/29/08 Yes, but it's not something you can apply to other - ThunderZ 19:06:53 05/29/08 Unfortunately, no WB right now. - jschrauwen 22:17:12 05/31/08 Before installing the TPs, either confirm there is an O2 - ThunderZ 18:52:05 06/01/08
Post a Followup	You cannot reply to this message because you are not logged in.