Subject	These are what I was talking about:
Posted by	BobbyT on May 27, 2008 at 3:27 AM
	This message has been viewed 262 times.
In Reply To	Bypassing the connector, but not bypassing the sensor... posted by BobbyT on May 27, 2008 at 03:23 AM
Message	If you were just talking about these: (straight crimp connectors that don't unplug), then it's a permanent connection so you might as well do it right with solder & heat shrink tubing.
Follow Ups	Is eliminating the knock sensor connector a bad - dyno 500 HP 300ZXTT 01:50:04 05/27/08 Bypassing the connector, but not bypassing the sensor... - BobbyT 03:23:15 05/27/08 These are what I was talking about: - BobbyT 03:27:57 05/27/08 Yup, thats what I did - dyno 500 HP 300ZXTT 10:46:26 05/27/08 Yes that's a good alternative - mine are done that way - jzack 08:07:55 05/27/08 As cut the wires futher down.... - dyno 500 HP 300ZXTT 10:51:48 05/27/08 The connector is just a convenience. - rojoloco (San Diego) 10:12:13 05/27/08
Post a Followup	You cannot reply to this message because you are not logged in.