Subject	OEM Oil Cooler Line Block-offs?
Posted by	jschrauwen on May 26, 2008 at 10:09 PM
	This message has been viewed 171 times.
In Reply To	Wow, no responses??? posted by jschrauwen on May 26, 2008 at 10:30 AM
Message	Well I finally found out what the oil filet thead and pitch size is - 3/4x16. I'd like to know a few things; 1. What would be a good size oil line to use to and from the Z1 oil cooler to maintain oil pressure levels? I was thinking AN-6? 2. Since I have a limited (short) use of a hoist I like to know before I go there what fittings/items I need to properly block off the oem rubber/steel lines from the oem oil cooler, oil pan and oem oil filter adapter. 1990 JDM RHD - Stage X 491.0 RWHP, 476.1 RWTQ, 18 PSI, Pump gas 26PSI w/Race gas = ???
Follow Ups	Oil Cooler Options - jschrauwen 08:44:25 05/25/08 Wow, no responses??? - jschrauwen 10:30:53 05/26/08 OEM Oil Cooler Line Block-offs? - jschrauwen 22:09:38 05/26/08 Re: OEM Oil Cooler Line Block-offs? - jschrauwen 05:41:35 05/27/08 oil lines - inferno 07:45:03 05/27/08 Which oil cooler did you order? Nismo, Stillen or Z1 - jschrauwen 20:55:05 05/27/08
Post a Followup	You cannot reply to this message because you are not logged in.