Subject	Re: 8 psi boost
Posted by	tsaitang on May 26, 2008 at 6:45 PM
	This message has been viewed 118 times.
In Reply To	8 psi boost posted by tsaitang on May 25, 2008 at 07:04 AM
Message	well, i preposted early should have read the tech section. :) but i think it may be in safe boost mode. Getting a knock sensor code. the owner before had a resistor solder in at the sensor....trying to figure out what to do now?
Follow Ups	8 psi boost - tsaitang 07:04:28 05/25/08 Run an ECU diag and see if you have any codes 1st. - ThunderZ 07:38:20 05/25/08 Do a boost leak test. You may have one or more - Audioquest 10:03:44 05/25/08 Re: 8 psi boost - tsaitang 18:45:43 05/26/08 If the 1M OHM resisitor is good, the problem is most likely - ThunderZ 22:22:53 05/26/08 Re: If the 1M OHM resisitor is good, the problem is most likely - tsaitang 08:49:16 05/27/08 Not sure, I never tested it like that. But I was able to - ThunderZ 20:50:49 05/27/08 no more code - tsaitang 14:19:13 05/28/08 Alright, way to fix the codes. Now I'd do what Audioquest - ThunderZ 21:40:10 05/28/08
Post a Followup	You cannot reply to this message because you are not logged in.