Subject	Just finsihed doing this can help
Posted by	MrPulldown on May 25, 2008 at 11:22 PM
	This message has been viewed 105 times.
In Reply To	replacing stock stereo and speakers. need help posted by speedy z on May 25, 2008 at 09:47 PM
Message	There are four wires. The two fat ones are to power the amp. All you need are the small ones. Cut the two thinner wires near the connector. Tape the connector up somewhere. You can ever get away with using the stock speaker and a new head unit by bypassing the amps. The sound is very good. As good as new speakers. But... Play music through the head unit. Do one speaker at a time. Take a multi meter and probe the two smaller wires. The produce a few volts. The reading will be postive or neg. If pos look at the probed wires. The one touching the reb probe is + the black -, and vice versa.
Follow Ups	replacing stock stereo and speakers. need help - speedy z 21:47:07 05/25/08 Just finsihed doing this can help - MrPulldown 23:22:50 05/25/08 Stock Bose speakers with head unit is a no-no... - thumper300zx 00:56:21 05/26/08 You are correct! (n/m) - twinturbineZ 01:01:29 05/26/08 Re: You are correct! - MrPulldown 01:46:00 05/26/08 The BOSE probably sounded better because the - ThunderZ 08:25:31 05/26/08 Re: The BOSE probably sounded better because the - thumper300zx 10:37:34 05/26/08 I don't know where I saw it- either on the speaker or - ThunderZ 12:20:03 05/26/08 Re: I don't know where I saw it- either on the speaker or - thumper300zx 18:02:51 05/26/08 I'm pretty sure it's 1 OHM. (n/m) - ThunderZ 06:46:24 05/27/08 Technically, all speakers have a varying impedance - BigTDogg (MA) 14:19:57 05/28/08 Would it fry the amp or the speaker? I have it the - ThunderZ 21:36:53 05/28/08 What? I was distracted by your sig :-) - BigTDogg (MA) 08:47:16 05/29/08 lol...thanks. (n/m) - ThunderZ 19:07:57 05/29/08 Re: Stock Bose speakers with head unit is a no-no... - red300zxtt101 01:08:51 05/27/08 The bose speakers are ok with the bose amps..that's it! (n/m) - twinturbineZ 14:43:26 05/27/08
Post a Followup	You cannot reply to this message because you are not logged in.