Subject	Also try to work the fastener back and forth, not just
Posted by	Gordo 93TT Daytona on May 23, 2008 at 7:25 PM
	This message has been viewed 132 times.
In Reply To	replacing tension rod connectors...all 3 nuts are seized posted by eliteturbotuner on May 21, 2008 at 08:20 PM
Message	trying to twist it off counter clockwise. Twisting the nut both ways, doubles the chances of breaking the joint loose. As a nut or bolt is tightened down, their mating surfaces are often "smeared" into a granular structure. It is often easier to break the seized joint by going with the grain of the smeared metal, as opposed to against the it. Once the joint is broken loose, a small cavity is created within the joint which in turn may be expanded upon. At the same time, this little bit of back and forth movement makes it easier for the penetrant to work its way into the threads. gordo _________________________________________________
Follow Ups	replacing tension rod connectors...all 3 nuts are seized - eliteturbotuner 20:20:04 05/21/08 PB Blaster is the only way to fly as far as penetrating - Audioquest 20:42:37 05/21/08 On the O2 sensors I used some freezing spray to get - jzack 20:50:53 05/21/08 PB Blaster and give it time to work, as in hours. - doug8867 21:14:21 05/21/08 Use PB Blaster, but let it sit overnight and keep spraying - ThunderZ 21:15:42 05/21/08 Re: replacing tension rod connectors...all 3 nuts are seized - PhilupondZ 08:54:22 05/22/08 ...and good command of the english language! (n/m) - Audioquest 19:53:14 05/22/08 Also try to work the fastener back and forth, not just - Gordo 93TT Daytona 19:25:27 05/23/08
Post a Followup	You cannot reply to this message because you are not logged in.