Subject	Use PB Blaster, but let it sit overnight and keep spraying
Posted by	ThunderZ on May 21, 2008 at 9:15 PM
	This message has been viewed 225 times.
In Reply To	replacing tension rod connectors...all 3 nuts are seized posted by eliteturbotuner on May 21, 2008 at 08:20 PM
Message	it every so often. The vibration from the impact gun helps get the PB or Liquid Wrench in the threads, even if they nuts don't break free the 1st few times w/ the gun. CRC also makes a freeze-off spray that does what jzack was saying. It's not as good as LW though.
Follow Ups	replacing tension rod connectors...all 3 nuts are seized - eliteturbotuner 20:20:04 05/21/08 PB Blaster is the only way to fly as far as penetrating - Audioquest 20:42:37 05/21/08 On the O2 sensors I used some freezing spray to get - jzack 20:50:53 05/21/08 PB Blaster and give it time to work, as in hours. - doug8867 21:14:21 05/21/08 Use PB Blaster, but let it sit overnight and keep spraying - ThunderZ 21:15:42 05/21/08 Re: replacing tension rod connectors...all 3 nuts are seized - PhilupondZ 08:54:22 05/22/08 ...and good command of the english language! (n/m) - Audioquest 19:53:14 05/22/08 Also try to work the fastener back and forth, not just - Gordo 93TT Daytona 19:25:27 05/23/08
Post a Followup	You cannot reply to this message because you are not logged in.