Subject	Yep thats it:)
Posted by	Bezza on May 20, 2008 at 7:23 PM
	This message has been viewed 502 times.
In Reply To	Piston-to-bore clearance is supposed to be .0025" posted by na300zx (OH) on May 20, 2008 at 06:19 PM
Message	Damn, Yep I forgot I went 0.001 over the box recommendation. This was on purpose though, see this post: [ http://www.twinturbo.net/nissan/300zx/forums/technical/view/1050747/Wiseco-Piston-to-Wall-Clearance.html ] So 0.001*pi = 0.003 extra circumference which would bring the top ring closer to what it should be. Thanks.
Follow Ups	Wiseco supplied rings - end gap - Bezza 10:02:22 05/20/08 Piston-to-bore clearance is supposed to be .0025" - na300zx (OH) 18:19:10 05/20/08 Yep thats it:) - Bezza 19:23:40 05/20/08 Bingo... piston to wall clearance and ring gap is more about - LitlElvis 10:30:30 05/22/08
Post a Followup	You cannot reply to this message because you are not logged in.