Subject	Piston-to-bore clearance is supposed to be .0025"
Posted by	na300zx (OH) on May 20, 2008 at 6:19 PM
	This message has been viewed 483 times.
In Reply To	Wiseco supplied rings - end gap posted by Bezza on May 20, 2008 at 10:02 AM
Message	Your cylinder is too big, and that is probably why you are having trouble with the rings. I would recommend going to .040" over at this point. If you stick with .020" over you will probably have a lot of piston slap and your engines life will be shortened.
Follow Ups	Wiseco supplied rings - end gap - Bezza 10:02:22 05/20/08 Piston-to-bore clearance is supposed to be .0025" - na300zx (OH) 18:19:10 05/20/08 Yep thats it:) - Bezza 19:23:40 05/20/08 Bingo... piston to wall clearance and ring gap is more about - LitlElvis 10:30:30 05/22/08
Post a Followup	You cannot reply to this message because you are not logged in.