Subject	yep (n/m)
Posted by	aliaZ on May 19, 2008 at 11:16 PM
	This message has been viewed 337 times.
In Reply To	MS manifolds were made with a flat spot to drill and tap. posted by Woody75 (Denver) on May 19, 2008 at 11:15 PM
Message
Follow Ups	EGT Sensor Mount - WHERE? - lawz 16:18:51 05/19/08 hERE - Spongerider :) 16:49:49 05/19/08 He's asking about installing an EGT sensor - ZXRider(SoCal) 17:10:45 05/19/08 (Total Hits: a lot). - Spongerider :) 18:27:55 05/19/08 ? - aliaZ 21:56:15 05/19/08 I think Dean is mistaking the EGT - ZXRider(SoCal) 00:11:21 05/20/08 You're right. I had a long day. - Spongerider :) 00:51:32 05/20/08 lol (n/m) - aliaZ 07:35:27 05/20/08 MS manifolds were made with a flat spot to drill and tap. - Woody75 (Denver) 23:15:36 05/19/08 yep (n/m) - aliaZ 23:16:43 05/19/08
Post a Followup	You cannot reply to this message because you are not logged in.