Subject	It all depends on the thickness of the gasket and
Posted by	Fast300 on May 19, 2008 at 12:25 AM
	This message has been viewed 113 times.
In Reply To	Clerance Question posted by 300znick on May 18, 2008 at 08:17 PM
Message	how much was removed off the heads and block. Without those measurements it is not possible to tell.
Follow Ups	Clerance Question - 300znick 20:17:52 05/18/08 It all depends on the thickness of the gasket and - Fast300 00:25:26 05/19/08 Re: It all depends on the thickness of the gasket and - 300znick 09:58:45 05/20/08 Are you sure those numbers are correct? - scottyfender 10:21:01 05/20/08 Maximum combined limit is .2 MM, or .008 in. - Fast300 22:01:38 05/20/08 So my combined .019" isn't going to work even if I... - scottyfender 23:01:57 05/20/08 Those are the factory specs, make your own conclusions (n/m) - Fast300 16:50:38 05/21/08
Post a Followup	You cannot reply to this message because you are not logged in.