Subject	Clerance Question
Posted by	300znick on May 18, 2008 at 8:17 PM
	This message has been viewed 154 times.
Message	ok i got my heads resurfaced and block resurfaced, and i got cometic MLS gakets and wiseco pistons... are my valves gunna hit pistons? i know it all depends on how much the machine shop takes of But if anyone else did the same you have a problem with valves hitting pistons??? thank you for input
Follow Ups	Clerance Question - 300znick 20:17:52 05/18/08 It all depends on the thickness of the gasket and - Fast300 00:25:26 05/19/08 Re: It all depends on the thickness of the gasket and - 300znick 09:58:45 05/20/08 Are you sure those numbers are correct? - scottyfender 10:21:01 05/20/08 Maximum combined limit is .2 MM, or .008 in. - Fast300 22:01:38 05/20/08 So my combined .019" isn't going to work even if I... - scottyfender 23:01:57 05/20/08 Those are the factory specs, make your own conclusions (n/m) - Fast300 16:50:38 05/21/08
Post a Followup	You cannot reply to this message because you are not logged in.