Subject	Dual MAF power and SAFC vs AVCR RPM monitor
Posted by	Shorebreak on May 17, 2008 at 2:59 PM
	This message has been viewed 228 times.
Message	I'm about to install a dual MAF setup and was wondering what type of wire i should use to hook up the SAFC to the 2nd MAF. Do I need to get a hook up from another harness?? Also, I recently installed a Apexi SAFC alongside my Apexi AVCR and noticed that the rpms on one differ from the other. The throttle is also about 4% off as well. Is one more accurate than the other? Is this normal?
Follow Ups	Dual MAF power and SAFC vs AVCR RPM monitor - Shorebreak 14:59:05 05/17/08 Any type of sheilded wire at least 16 gauge..I used - twinturbineZ 15:25:41 05/17/08
Post a Followup	You cannot reply to this message because you are not logged in.