Subject	This is after doing an NA to NA swap on a 2+2.
Posted by	enthuZiast on May 15, 2008 at 7:26 PM
	This message has been viewed 123 times.
In Reply To	Can you tell if the idle is increasing to compensate for posted by Dave N on May 15, 2008 at 07:15 PM
Message	yes, there was some access. belts that were adjusted. I sprayed wd40 into the idle control valve to clean/loosen/lube the insides while the car was idling. This helped the idle as it is consistently below 1K during idle and smooth. The idle does compensate for the A/C being on and I do not think its because of a low idle that is causing the vibration. Thanks for the reply. <<< Slow in & Fast out >>>
Follow Ups	motor vibrates when A/C is on. - enthuZiast 18:47:10 05/15/08 Can you tell if the idle is increasing to compensate for - Dave N 19:15:55 05/15/08 This is after doing an NA to NA swap on a 2+2. - enthuZiast 19:26:50 05/15/08 Is the pulley bent? (n/m) - twinturbineZ 19:48:39 05/15/08
Post a Followup	You cannot reply to this message because you are not logged in.