Subject	Re: For the break in run it for about 30min at idle or 2k rp
Posted by	cameron40420 on May 14, 2008 at 7:25 AM
	This message has been viewed 152 times.
In Reply To	For the break in run it for about 30min at idle or 2k rpms. posted by 5280Z_nightstalker on May 14, 2008 at 12:16 AM
Message	I tried the shopvac while cranking again, still didn't work, so I just started it up, and sure enough the oil pressure shot up quickly to around 60. Now, time/weather permitting, I'll test drive it today to make sure I didn't f#ck anything up.
Follow Ups	Priming engine after rebuild - cameron40420 20:11:30 05/13/08 I always just start the car and watch the pressure gauge. (n/m) - Woody75 (Denver) 20:14:25 05/13/08 Re: I always just start the car and watch the pressure gauge - cameron40420 20:49:41 05/13/08 run the shopvac while cranking ... - Guapo 21:00:54 05/13/08 Re: run the shopvac while cranking ... - txq45 21:05:14 05/13/08 yep (n/m) - aliaZ 10:21:24 05/14/08 For the break in run it for about 30min at idle or 2k rpms. - 5280Z_nightstalker 00:16:11 05/14/08 Re: For the break in run it for about 30min at idle or 2k rp - cameron40420 07:25:22 05/14/08 Never worked for me. - Woody75 (Denver) 09:58:04 05/14/08
Post a Followup	You cannot reply to this message because you are not logged in.