Subject	Ya its like if you were doing a heater hose on your house.
Posted by	5280Z_nightstalker on May 14, 2008 at 12:47 AM
	This message has been viewed 138 times.
In Reply To	I do it like jzack, but the submersion sounds like a good posted by ThunderZ on May 14, 2008 at 12:34 AM
Message	After you have soldered it you would spray it with soap water to see if it leaks because the soap will bubble if it does. Simple concept but sure as hell worked on my car and when messing with fuel you want to have that 100% certainty that you wont have to use a fire extinguisher on your Z.
Follow Ups	injector o-ring question - 05titanle 19:44:29 05/13/08 Re: injector o-ring question - txq45 20:02:38 05/13/08 You could pressurize just the rail part of the system - jzack 20:55:39 05/13/08 best way that I did it was take air compressor and screw on - 5280Z_nightstalker 00:18:46 05/14/08 I do it like jzack, but the submersion sounds like a good - ThunderZ 00:34:57 05/14/08 Ya its like if you were doing a heater hose on your house. - 5280Z_nightstalker 00:47:20 05/14/08 Yep, sounds like a good way too - but I think he's - jzack 18:48:03 05/14/08
Post a Followup	You cannot reply to this message because you are not logged in.