Subject	best way that I did it was take air compressor and screw on
Posted by	5280Z_nightstalker on May 14, 2008 at 12:18 AM
	This message has been viewed 125 times.
In Reply To	You could pressurize just the rail part of the system posted by jzack on May 13, 2008 at 08:55 PM
Message	fitting so you can create pressure in the rails. Cap one end as you said but sink the rail in water and you should be able to see air bubbles coming out if its not tight and right.
Follow Ups	injector o-ring question - 05titanle 19:44:29 05/13/08 Re: injector o-ring question - txq45 20:02:38 05/13/08 You could pressurize just the rail part of the system - jzack 20:55:39 05/13/08 best way that I did it was take air compressor and screw on - 5280Z_nightstalker 00:18:46 05/14/08 I do it like jzack, but the submersion sounds like a good - ThunderZ 00:34:57 05/14/08 Ya its like if you were doing a heater hose on your house. - 5280Z_nightstalker 00:47:20 05/14/08 Yep, sounds like a good way too - but I think he's - jzack 18:48:03 05/14/08
Post a Followup	You cannot reply to this message because you are not logged in.