Subject	For the break in run it for about 30min at idle or 2k rpms.
Posted by	5280Z_nightstalker on May 14, 2008 at 12:16 AM
	This message has been viewed 32 times.
In Reply To	Priming engine after rebuild posted by cameron40420 on May 13, 2008 at 08:11 PM
Message	I have always wondered though could you prime the motor by just simply pulling the fuel pump fuse and cranking it over as the car will not start but should pump oil right? Just curious hopefully someone can say something.
Follow Ups	Priming engine after rebuild - cameron40420 20:11:30 05/13/08 I always just start the car and watch the pressure gauge. (n/m) - Woody75 (Denver) 20:14:25 05/13/08 Re: I always just start the car and watch the pressure gauge - cameron40420 20:49:41 05/13/08 run the shopvac while cranking ... - Guapo 21:00:54 05/13/08 Re: run the shopvac while cranking ... - txq45 21:05:14 05/13/08 yep (n/m) - aliaZ 10:21:24 05/14/08 For the break in run it for about 30min at idle or 2k rpms. - 5280Z_nightstalker 00:16:11 05/14/08 Re: For the break in run it for about 30min at idle or 2k rp - cameron40420 07:25:22 05/14/08 Never worked for me. - Woody75 (Denver) 09:58:04 05/14/08
Post a Followup	You cannot reply to this message because you are not logged in.