Subject	Re: I think most people just put in a 90 fitting instead.
Posted by	ttzcadet on May 10, 2008 at 11:41 PM
	This message has been viewed 131 times.
In Reply To	I think most people just put in a 90 fitting instead. posted by Woody75 (Denver) on May 10, 2008 at 11:30 PM
Message	Yeah I searched to find a 90 deg fitting like that but couldn't find any in the right size and thread pitch (14mm I think?). Do you forsee any problems heating up the aluminum and bending it slightly? I'm pretty sure there's some room behind that log that sticks out. I know there's a valve in the log, but I think it would be behind where any bending would occur.
Follow Ups	Urgent advice needed- oil cooler line won't clear housing - ttzcadet 23:08:57 05/10/08 I think most people just put in a 90 fitting instead. - Woody75 (Denver) 23:30:26 05/10/08 Re: I think most people just put in a 90 fitting instead. - ttzcadet 23:41:37 05/10/08 I wouldn't bend it. Call SGP or Kyle. - Woody75 (Denver) 12:05:32 05/11/08 Re: I wouldn't bend it. Call SGP or Kyle. - ttzcadet 19:12:12 05/11/08
Post a Followup	You cannot reply to this message because you are not logged in.