Subject	Wiggle the inj connector and see if it comes and goes.
Posted by	Spddracer on May 10, 2008 at 9:52 PM
	This message has been viewed 188 times.
In Reply To	cylinder 2 misfire... posted by onewheelf4 on May 10, 2008 at 09:21 PM
Message	Sometimes its just a poor connection due to corrosion. OHMing the injector will tell you if the injector is bad or not. I would suck monkey balls to get my Z black... (n/m) - scottyfender 02/22/08 23:14:01
Follow Ups	cylinder 2 misfire... - onewheelf4 21:21:38 05/10/08 Wiggle the inj connector and see if it comes and goes. - Spddracer 21:52:57 05/10/08 Re: Wiggle the inj connector and see if it comes and goes. - onewheelf4 08:31:57 05/11/08 Dental pick will get the clip off for you. - Spddracer 17:30:21 05/11/08 had similar problem - aidemsined (to) 03:29:19 05/12/08 Re: had similar problem - onewheelf4 07:49:28 05/12/08 keep in mind - aidemsined (to) 10:53:09 05/13/08 yea it was dead. i already pulled it, changed it and - onewheelf4 13:23:55 05/13/08
Post a Followup	You cannot reply to this message because you are not logged in.