Subject	And just so you know, this "denting" that can occur
Posted by	Crim on May 10, 2008 at 10:16 AM
	This message has been viewed 10 times.
In Reply To	Not talking about the hole. posted by Woody75 (Denver) on May 08, 2008 at 03:54 PM
Message	is VERY small. Its not like a big dent you could look at. I believe the oil pickup tube is only a few mm off the bottom of the pan, so it doesn't take much. I ran into this very same problem with a JDM SR20DE. Always bang out the bottom of the oil pan from a used motor, now matter how good it appears to be. 1990 2+2 TwinTurbo 1992 NX2000 (SR20DE-T) Represent your Z on NissanWar.com!
Follow Ups	this may be a adolescent question, but after my new jdm engi - pearlyellowtt 11:01:53 05/08/08 Did you verify the oil pan is ok yet? - Woody75 (Denver) 11:40:44 05/08/08 its okay, the small puncture hole is fixable. its not touchc - pearlyellowtt 15:16:13 05/08/08 Not talking about the hole. - Woody75 (Denver) 15:54:51 05/08/08 And just so you know, this "denting" that can occur - Crim 10:16:57 05/10/08
Post a Followup	You cannot reply to this message because you are not logged in.