Subject	Wiring dual maf w AFC NEO w Boomslang harness
Posted by	ZonaZ on May 09, 2008 at 10:01 PM
	This message has been viewed 455 times.
Message	Here is where the AFC NEO Boomslang harness is going: yellow - pin 27 - air flow meter brown - pin 60 - ground black - pin 60 - ground red - pin 59 - ignition power purple - pin 59 - ignition power white - pin 27 - air flow meter grey - pin 38 - throttle signal green - pin 7 - rpm (tach) After I solder on my shielded wire, splice (or is this a cut?) the white to the white (or yellow) on pin 27. Splice the black wire to pin 26 MAF sig ground (not listed above) or to pin 60?. Would that work or do I need to do something else? thanks for any details\info. Here are the maf wires, already have maf power and ground soldered in. Have shielded wire just need to solder and run to ecu area and boomslang harness. Boomslang harness: John
Follow Ups	Wiring dual maf w AFC NEO w Boomslang harness - ZonaZ 22:01:49 05/09/08 cut and paste.............. - twinturbineZ 00:10:11 05/10/08 right, saw it. no boomslang harness, no neo - ZonaZ 11:49:34 05/10/08 Couple of clarifications - ThunderZ 08:59:30 05/10/08 this is the boomslang with NEO sub-harness built in - ZonaZ 11:36:48 05/10/08 In the NEO wire diagram, they identify connection diagram - ZonaZ 12:58:12 05/10/08 Look at the Rb26 wiring diagram just below of the one - ThunderZ 08:28:34 05/11/08 the Y branch doesn't apply because we don't have the - ZonaZ 13:37:23 05/11/08 Correct. No worries, it's good to be careful. The Yellow - ThunderZ 19:17:54 05/11/08 JOHN....you're making this way too difficult!! - twinturbineZ 14:12:22 05/10/08 I am not using the harness that came with the NEO - ZonaZ 17:37:23 05/10/08 You got it...finally...Do you have the original - twinturbineZ 17:41:53 05/10/08 thx, just trying to nail down the blue wire, spoke to - ZonaZ 13:32:19 05/11/08 Re: thx, just trying to nail down the blue wire, spoke to - WazTTed 05:05:28 05/12/08
Post a Followup	You cannot reply to this message because you are not logged in.