Subject	Re: Hi Shawn, I think I'm the guy spicyZ was referring to. I
Posted by	ZTurboFan on May 08, 2008 at 4:15 PM
	This message has been viewed 142 times.
In Reply To	Hi Shawn, I think I'm the guy spicyZ was referring to. I posted by Inzane on May 08, 2008 at 02:29 PM
Message	Well, I'm wondering what wire I need to use. I'm assuming I just run whatever this wire is into the switch, and out of the switch back to where I spliced it. Problem is I need the switch so I can mount it to factory location (ideally) and I need to know what wire! We can figure this out on PM on beyond...LOL...if you know the wire...
Follow Ups	Neutral Safety - ZTurboFan 11:37:02 05/08/08 Correction - ZTurboFan 11:39:16 05/08/08 Someone on here from Alberta has done this - spicyZ 13:44:34 05/08/08 That was me. (n/m) - Inzane 14:15:35 05/08/08 Ah! My bad.. thanks for catching this and responding. (n/m) - spicyZ 14:37:27 05/08/08 Hi Shawn, I think I'm the guy spicyZ was referring to. I - Inzane 14:29:02 05/08/08 Re: Hi Shawn, I think I'm the guy spicyZ was referring to. I - ZTurboFan 16:15:04 05/08/08
Post a Followup	You cannot reply to this message because you are not logged in.