Subject	Damn, I wish I'd known you were doing your harness install.
Posted by	Inzane on May 08, 2008 at 2:19 PM
	This message has been viewed 144 times.
In Reply To	no right 02 sensor signal posted by vorpalZ on May 07, 2008 at 11:04 PM
Message	I would've liked to have seen how bad that job is (going through the firewall, etc.) as I have a brand new 95TT harness myself that I'll be installing some day in the future. Inzane (formerly Z-Jay)
Follow Ups	no right 02 sensor signal - vorpalZ 23:04:03 05/07/08 What about doing the O2 self diag directly from the ECU? (n/m) - Dave N 00:29:20 05/08/08 when I set the ECU in Mode II and run @ 2000 RPM - vorpalZ 07:47:40 05/08/08 Is it possible you've got a pinched/cut wire from doing - Dave N 10:20:22 05/08/08 I'd just do a meter continuity check between the ECU - jzack 18:14:31 05/08/08 In vorpalZ's OP he mentioned he already did the continuity - Inzane 10:02:57 05/09/08 Damn, I wish I'd known you were doing your harness install. - Inzane 14:19:45 05/08/08
Post a Followup	You cannot reply to this message because you are not logged in.