Subject	this may be a adolescent question, but after my new jdm engi
Posted by	pearlyellowtt on May 08, 2008 at 11:01 AM
	This message has been viewed 143 times.
Message	engine being put in, its valves are noisy, i am guessing due to sitting with no oil in it. My question is, should i just let it run and circulate oil into the valves or is there something else i can do to to be safer, obviously other than taking apart the motor to oil them
Follow Ups	this may be a adolescent question, but after my new jdm engi - pearlyellowtt 11:01:53 05/08/08 Did you verify the oil pan is ok yet? - Woody75 (Denver) 11:40:44 05/08/08 its okay, the small puncture hole is fixable. its not touchc - pearlyellowtt 15:16:13 05/08/08 Not talking about the hole. - Woody75 (Denver) 15:54:51 05/08/08 And just so you know, this "denting" that can occur - Crim 10:16:57 05/10/08
Post a Followup	You cannot reply to this message because you are not logged in.