Subject	Is it possible you've got a pinched/cut wire from doing
Posted by	Dave N on May 08, 2008 at 10:20 AM
	This message has been viewed 142 times.
In Reply To	when I set the ECU in Mode II and run @ 2000 RPM posted by vorpalZ on May 08, 2008 at 07:47 AM
Message	the wire harness install? If you depinned any of the ECU connectors, is it possible something got switched or not fully reinserted? It is strange that you're getting spastic flashing of the CEL now. Dave Sig Quotes: "Your sausage scares me!" - TT-XTZ 6/13/05 "Or he's having a rough week like the rest of us and decided to take out his agressions of not being breast fed on me." BigTDogg 15:45, 09/25/03 "Pick her up from day care and take her to Dairy Queen for a snow cone." YugoBernie 1/7/04 of course those are canadian bannings and beatings, which after the conversion rate is really only a "hey! stop that!" Chris(NJ) 1/14/04 see the green "n" next to my name? what's COZ? (n/m) - 300zx88 8/11/04
Follow Ups	no right 02 sensor signal - vorpalZ 23:04:03 05/07/08 What about doing the O2 self diag directly from the ECU? (n/m) - Dave N 00:29:20 05/08/08 when I set the ECU in Mode II and run @ 2000 RPM - vorpalZ 07:47:40 05/08/08 Is it possible you've got a pinched/cut wire from doing - Dave N 10:20:22 05/08/08 I'd just do a meter continuity check between the ECU - jzack 18:14:31 05/08/08 In vorpalZ's OP he mentioned he already did the continuity - Inzane 10:02:57 05/09/08 Damn, I wish I'd known you were doing your harness install. - Inzane 14:19:45 05/08/08
Post a Followup	You cannot reply to this message because you are not logged in.