| Message |
I have the H beam Eagle Rods. The stock rods have a whole in the clamp side for the oil squirters, the eagle rods don't. Will this cause some kind of pressure problem because the oil wouldn't have anywhere to go once it's in between the bearing and crank? I am not talking about an over all pressure problem, I mean at the rod where it clamps to the crank. Once the oil gets between the crank and bearing on the rod, will it have any place to get out for fresh oil to replace it?
 "Well I have an ex-wife, a girlfriend with 2 kids, 4 kids of my own, a boss and, a mother. I don't have any more room for making people happy."
"She's always wet and hot and purrs when I slide inside of her. She screams when I put my foot down and isn't too hard to control. She is usually straight but she slides her rear out when I ask her too. Always gives me a boost. Stays with me and leaves the other guys behind. She is even more fun when her top is off...so free. Sometimes a friend will join in, male or female, and we both enjoy her. Plus she is a non smoker...what more can you ask for?"
A few questions to ask....about the car of course. 1. Do the tops come off?
2. Does it leak fluids?
3. How is the under carriage?
4. Have the air bags been out?
5. Tears in the seat?
6. Electroincs work?
7. Been hit from the rear?
8. Does it get hot?
9. Has it been lubed?
10. Any body work done?
11. Takes a good waxing?
12. Driven hard?
13. Smoker?
|
 |
