Subject	Re: Engine Removal Bolts
Posted by	J Taylor on May 05, 2008 at 8:22 PM
	This message has been viewed 196 times.
In Reply To	Engine Removal Bolts posted by whasmack on May 05, 2008 at 06:06 PM
Message	I've pulled plenty or motors and have never used any special bolts. I have a plastic bin of bolts from cars I've parted out in the past. I'll usually just grab one that will thread in somewhere on the motor and put it through a chain. That or find on on the motor like on an AC or PS bracket, etc. If I'm just pulling a short block I'll use a headbolt sometimes. Hope this helps. JT :I am about ready to pull my engine out. I already tried to replace the head gasket w/o pulling the engine, but my fat hands can't get in there. :I am going to attach the longer bolts on the side of the engine, but I am not sure what grade bolts I need. :I found some at OSH, but they did not specify what grade. :Does anyone have a recommendation?
Follow Ups	Engine Removal Bolts - whasmack 18:06:59 05/05/08 Re: Engine Removal Bolts - J Taylor 20:22:09 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.