Subject	Re: Are you sure the DP is getting properly (and fully) seated
Posted by	cobaltgreenz32 on May 05, 2008 at 4:30 PM
	This message has been viewed 176 times.
In Reply To	Are you sure the DP is getting properly (and fully) seated posted by Dave N on May 05, 2008 at 03:10 PM
Message	C:\Documents and Settings\Mark\My Documents\My Pictures\IMG_1911.jpg That is the hole on the bottom of the flange where the right most stud goes through and when I mated it to the turbo, it looked as though the nut would hit the main dp pipe
Follow Ups	promblems with LaBree HELP!!! - cobaltgreenz32 14:16:19 05/05/08 Are you sure the DP is getting properly (and fully) seated - Dave N 15:10:52 05/05/08 Re: Are you sure the DP is getting properly (and fully) seated - cobaltgreenz32 16:27:15 05/05/08 Re: Are you sure the DP is getting properly (and fully) seated - cobaltgreenz32 16:30:27 05/05/08 You need to upload the picture from your computer to an - Dave N 16:51:59 05/05/08 Contact labree. (n/m) - Spongerider :) 15:17:03 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.