Subject	Please tell me what I want to hear
Posted by	mlov(NJ) on May 05, 2008 at 8:10 AM
	This message has been viewed 237 times.
Message	Last Fall I purchased a new EFI harness for my 90 NA auto. The harness is actually for a 92 NA (nissan part #B4011-45P01) and was told it would work on a 90. So I finally replaced the harness, de-pinned the white connector to fit thru the firewall....when I began putting the pins back in I looked at the old white connector for reference and noticed the middle section had 4 wires and the new harness white connector only had 3. Every other wire was an exact match. What is different w/the 92 harness? Please tell me I dont have to rip this harness back out after 8 hrs of work.
Follow Ups	Please tell me what I want to hear - mlov(NJ) 08:10:45 05/05/08 I don't know what the extra wires are for, but I know - ZEngineer (Dallas next month) 08:29:56 05/05/08 I did this w/the motor in and only de-pinned the white.. - mlov(NJ) 08:33:38 05/05/08 Anyone, I'm really uneasy about this. (n/m) - mlov(NJ) 10:12:45 05/05/08 You will be fine - na300zx (OH) 10:20:13 05/05/08 Did you notice the missing wire with yous? I also have an - mlov(NJ) 10:24:38 05/05/08 I didn't de-pin any connectors. I had the engine out so I - na300zx (OH) 11:10:09 05/05/08 2nd. (n/m) - Bernie (NoVA) 10:52:09 05/05/08 What would happen if I installed a 5spd harness in a.. - mlov(NJ) 13:32:39 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.