Subject	Take it to a machine shop have it decked, you can buy...
Posted by	Sleeper_TTZ(SeKy) on May 04, 2008 at 9:52 PM
	This message has been viewed 117 times.
In Reply To	Photos Here posted by ZTurboFan on May 03, 2008 at 11:19 PM
Message	a thicker head gasket to keep the compression stock. But you definitely need to get that thing machined. While its there they can check the cylinder's to make sure there isn't any damage to them either. TrueLinePerformance Car enthusiast for the car enthusiast. "I'm tired of being lucky." My Wife "I'm mad because I'm not stupid." My Wife
Follow Ups	Cylinder Damage, Evaluate Please - ZTurboFan 23:16:25 05/03/08 Photos Here - ZTurboFan 23:19:23 05/03/08 I'd be mostly concerned about head gasket seal *AND* - LitlElvis 10:32:50 05/04/08 Take it to a machine shop have it decked, you can buy... - Sleeper_TTZ(SeKy) 21:52:07 05/04/08 Another Photo - ZTurboFan 23:19:59 05/03/08 You should be fine - I can't recall how far down the first - Dave N 00:37:33 05/04/08 2nd it looks like youll be alright. Since when are you in - 5280Z_nightstalker 01:53:02 05/04/08 Re: 2nd it looks like youll be alright. Since when are you in - ZTurboFan 11:19:28 05/04/08 Cometic gasket won't solve your problem >> - LitlElvis 12:25:44 05/04/08 I agree with you was that block ever machined and resurfaced - 5280Z_nightstalker 12:57:53 05/04/08 2nd, the block need to be bore out 0.5mm at least. (n/m) - icsamerica 17:56:05 05/04/08 It's a phase I'm going through. :-P - Dave N 12:29:29 05/04/08 Hey Dave, hope you're doing well... wanna do my 60k? (n/m) - 300ZMang 20:29:07 05/04/08 Sure. Drive out to SoCal and I'll be more than happy to - Dave N 10:40:46 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.