Subject	SBC III Boost Controller Display
Posted by	msmith on May 04, 2008 at 9:00 PM
	This message has been viewed 37 times.
Message	Ok following up on this--- [ http://twinturbo.net/nissan/300zx/forums/technical/view/1058261/SBC-i-D-III-Not-powering-on.html ] I took apart my center console and pulled all the wiring out. I tested that there was power entering the little sbc box and there WAS. I than tested to see if power was transfering from the box to the display..i wasnt sure which was the ground or which was the hot but it didnt look like any power was going from the box to the display. My question is i want to run power to the display to see if it turns on. What voltage can i use to power the sbc display unit? I dont want to short out the circuit. Pls help me! Thanks 1990 300zx TT
Follow Ups	SBC III Boost Controller Display - msmith 21:00:54 05/04/08 Probably 12v, but I would email the manufacturer. (n/m) - .z 21:51:19 05/04/08
Post a Followup	You cannot reply to this message because you are not logged in.