Subject	have you double checked everything in the engine bay?
Posted by	Waggz on May 04, 2008 at 3:23 PM
	This message has been viewed 135 times.
In Reply To	I disconnected the det connector and got 55>still no power posted by irieblue on May 04, 2008 at 01:59 PM
Message	Made sure all vacuum lines were where they are supposed to be, double checked to see if the cam sprockets line up correctly, make sure that the electrical connections are good? Did you double check your work to see if it was done properly? **SELLING: 2.5" test pipes, Greddy EVO II catback, HKS intercoolers, Single pop w/ velocity stack, damaged VIS carbon fiber hood. **SELLING: Stock >> driveshaft, 6 stock TT injectors with rail, new style brand new rail, intercoolers, intercooler/intake piping.
Follow Ups	I have nooo power!! Help?? - irieblue 10:57:12 05/04/08 code 34 is your det sensor. Replace or bypass it. (n/m) - Waggz 11:06:31 05/04/08 Re: code 34 is your det sensor. Replace or bypass it. - irieblue 11:09:04 05/04/08 34 code switches you the low octane maps. - TheSlimOne 11:15:42 05/04/08 Re: 34 code switches you the low octane maps. - irieblue 11:42:49 05/04/08 I disconnected the det connector and got 55>still no power - irieblue 13:59:50 05/04/08 have you double checked everything in the engine bay? - Waggz 15:23:23 05/04/08 You have to put a 1 Mega Ohm resistor in the female side - TheSlimOne 19:40:27 05/04/08 Re: You have to put a 1 Mega Ohm resistor in the female side - irieblue 22:36:04 05/04/08 If you disconnected the det sensor and the code is gone then - TheSlimOne 23:22:18 05/04/08 I would check your timing job - 300ZMang 20:24:08 05/04/08 Re: I would check your timing job - irieblue 22:38:35 05/04/08 Re: I have nooo power!! Help?? - Noncon 21:30:28 05/04/08 Re: Re: I have nooo power!! Help?? - irieblue 22:43:37 05/04/08 Re: Re: I have nooo power!! Help?? - irieblue 14:28:24 05/05/08 Ohmmeter, 10-14 ohms is normal (n/m) - Noncon 20:49:49 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.