Subject	I disconnected the det connector and got 55>still no power
Posted by	irieblue on May 04, 2008 at 1:59 PM
	This message has been viewed 150 times.
In Reply To	Re: 34 code switches you the low octane maps. posted by irieblue on May 04, 2008 at 11:42 AM
Message	I disconnected the det connector and the battery and got code 55 so I went out for a drive and I still had no power, especially at the low end. I also checked the codes again after the drive to see if it might have been the wiring to the ecu or something but it still says 55...!!Frustrated!!!...I'm about to try and look up an O2 sensor check any words of wisdom/antidepressants are welcome...
Follow Ups	I have nooo power!! Help?? - irieblue 10:57:12 05/04/08 code 34 is your det sensor. Replace or bypass it. (n/m) - Waggz 11:06:31 05/04/08 Re: code 34 is your det sensor. Replace or bypass it. - irieblue 11:09:04 05/04/08 34 code switches you the low octane maps. - TheSlimOne 11:15:42 05/04/08 Re: 34 code switches you the low octane maps. - irieblue 11:42:49 05/04/08 I disconnected the det connector and got 55>still no power - irieblue 13:59:50 05/04/08 have you double checked everything in the engine bay? - Waggz 15:23:23 05/04/08 You have to put a 1 Mega Ohm resistor in the female side - TheSlimOne 19:40:27 05/04/08 Re: You have to put a 1 Mega Ohm resistor in the female side - irieblue 22:36:04 05/04/08 If you disconnected the det sensor and the code is gone then - TheSlimOne 23:22:18 05/04/08 I would check your timing job - 300ZMang 20:24:08 05/04/08 Re: I would check your timing job - irieblue 22:38:35 05/04/08 Re: I have nooo power!! Help?? - Noncon 21:30:28 05/04/08 Re: Re: I have nooo power!! Help?? - irieblue 22:43:37 05/04/08 Re: Re: I have nooo power!! Help?? - irieblue 14:28:24 05/05/08 Ohmmeter, 10-14 ohms is normal (n/m) - Noncon 20:49:49 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.