Subject	Cometic gasket won't solve your problem >>
Posted by	LitlElvis on May 04, 2008 at 12:25 PM
	This message has been viewed 138 times.
In Reply To	Re: 2nd it looks like youll be alright. Since when are you in posted by ZTurboFan on May 04, 2008 at 11:19 AM
Message	that deck surface is nasty, no gasket will help you there. Also, from the looks of the rolled edges on the water jacket holes it looks like someone "cleaned" the deck with a Scotchbrite disk on an air-tool. Not flat = not good.
Follow Ups	Cylinder Damage, Evaluate Please - ZTurboFan 23:16:25 05/03/08 Photos Here - ZTurboFan 23:19:23 05/03/08 I'd be mostly concerned about head gasket seal *AND* - LitlElvis 10:32:50 05/04/08 Take it to a machine shop have it decked, you can buy... - Sleeper_TTZ(SeKy) 21:52:07 05/04/08 Another Photo - ZTurboFan 23:19:59 05/03/08 You should be fine - I can't recall how far down the first - Dave N 00:37:33 05/04/08 2nd it looks like youll be alright. Since when are you in - 5280Z_nightstalker 01:53:02 05/04/08 Re: 2nd it looks like youll be alright. Since when are you in - ZTurboFan 11:19:28 05/04/08 Cometic gasket won't solve your problem >> - LitlElvis 12:25:44 05/04/08 I agree with you was that block ever machined and resurfaced - 5280Z_nightstalker 12:57:53 05/04/08 2nd, the block need to be bore out 0.5mm at least. (n/m) - icsamerica 17:56:05 05/04/08 It's a phase I'm going through. :-P - Dave N 12:29:29 05/04/08 Hey Dave, hope you're doing well... wanna do my 60k? (n/m) - 300ZMang 20:29:07 05/04/08 Sure. Drive out to SoCal and I'll be more than happy to - Dave N 10:40:46 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.