Subject	Cylinder Damage, Evaluate Please
Posted by	ZTurboFan on May 03, 2008 at 11:16 PM
	This message has been viewed 285 times.
Message	Little knick on the cylinder. How big of a problem is this if I go with a metal gasket. Cometic. http://i71.photobucket.com/albums/i141/photodump_2006/Twin%20Turbo/IMG_3943.jpg ]"> Suggestions?
Follow Ups	Cylinder Damage, Evaluate Please - ZTurboFan 23:16:25 05/03/08 Photos Here - ZTurboFan 23:19:23 05/03/08 I'd be mostly concerned about head gasket seal *AND* - LitlElvis 10:32:50 05/04/08 Take it to a machine shop have it decked, you can buy... - Sleeper_TTZ(SeKy) 21:52:07 05/04/08 Another Photo - ZTurboFan 23:19:59 05/03/08 You should be fine - I can't recall how far down the first - Dave N 00:37:33 05/04/08 2nd it looks like youll be alright. Since when are you in - 5280Z_nightstalker 01:53:02 05/04/08 Re: 2nd it looks like youll be alright. Since when are you in - ZTurboFan 11:19:28 05/04/08 Cometic gasket won't solve your problem >> - LitlElvis 12:25:44 05/04/08 I agree with you was that block ever machined and resurfaced - 5280Z_nightstalker 12:57:53 05/04/08 2nd, the block need to be bore out 0.5mm at least. (n/m) - icsamerica 17:56:05 05/04/08 It's a phase I'm going through. :-P - Dave N 12:29:29 05/04/08 Hey Dave, hope you're doing well... wanna do my 60k? (n/m) - 300ZMang 20:29:07 05/04/08 Sure. Drive out to SoCal and I'll be more than happy to - Dave N 10:40:46 05/05/08
Post a Followup	You cannot reply to this message because you are not logged in.