Subject	Installing upper window guide rail on driver side and need
Posted by	jzack on May 03, 2008 at 8:00 PM
	This message has been viewed 39 times.
Message	some advice... - Old upper guide rail was removed. My old window rivet bolt snapped, so getting the guide rail out was easy. - New window rivet bolt, stud + white nylon swivel cap have been attached to the window. - Window is now rolled all the way down - Trying to slide the guide rail down onto the nylon swivel cap but it's too tight? Seems like the lower end of the guide rail is pinched a little bit tighter than the top part (maybe to keep the window from rattling when window is down?) - Is this how I'm suppose to be installing the guide rail or is there some other trick to this?
Follow Ups	Installing upper window guide rail on driver side and need - jzack 20:00:52 05/03/08 Figured it out!!! Had to use my heat gun on the end - jzack 10:40:56 05/04/08
Post a Followup	You cannot reply to this message because you are not logged in.