Subject	I believe I tried that as well
Posted by	TTFairladyZ on April 29, 2008 at 8:20 PM
	This message has been viewed 133 times.
In Reply To	Or drill some holes and crush it with pliers posted by Broke_as_**** on April 29, 2008 at 08:12 PM
Message	my bits were no match for it though. Tried chiseling at the auto bushing too, but it dulled my chisels before even making a mark on the bushing. The dremel bit cut through like butter, through my experience. here was my post about it a while ago La-Z-Link 1990 Nissan 300ZXTT Stage III+
Follow Ups	trying to change over pilot bushing from auto to 5spd - pearlyellowtt 19:49:10 04/29/08 Yes - TTFairladyZ 20:09:23 04/29/08 Or drill some holes and crush it with pliers - Broke_as_**** 20:12:49 04/29/08 I believe I tried that as well - TTFairladyZ 20:20:57 04/29/08 thanks, that will be tommorrows project (n/m) - pearlyellowtt 20:34:27 04/29/08 i used this, had it out in 2 minutes - john90zxtt(OH) 20:45:23 04/29/08 I used the $7 plumbing parts pull, 2 minutes tops.. - bjZ 21:36:52 04/29/08 2nd (n/m) - sino26 12:00:19 05/01/08 I spent an hour trying to get it out with a dremel & failed - Crim 21:26:50 04/29/08 I used a sharpened screw driver as a chisel, chopped it up - nemo1080 (Iowa) 16:13:04 05/01/08
Post a Followup	You cannot reply to this message because you are not logged in.