Subject	Update: Sprocket Puller
Posted by	Thomas+10 on April 29, 2008 at 12:39 PM
	This message has been viewed 130 times.
In Reply To	Timing Belt Gear Removal Problem posted by Thomas+10 on April 26, 2008 at 09:29 PM
Message	Used a small drill to drill two small diamiter holes then a little bit larger drill to widen the holes. Threaded holes and put thin bolts in and attached to puller. No problems with puller. Had to break second drill to get enough room between heat exchanger for AC and sprocket. Thanks to this site for information. Timing Belt Job complete. Ton S. S+10
Follow Ups	Timing Belt Gear Removal Problem - Thomas+10 21:29:05 04/26/08 That's not the drive shaft - ZXRider(SoCal) 21:45:34 04/26/08 Use a pry bar to pry it. If that doesn't work then you'll - doug8867 21:46:00 04/26/08 Do not PRY on the oil pump. (n/m) - Spddracer 06:12:23 04/27/08 theres a few things you can do - sandmanz32 20:18:09 04/28/08 Update: Sprocket Puller - Thomas+10 12:39:46 04/29/08
Post a Followup	You cannot reply to this message because you are not logged in.