Subject	I have seen this a few times.
Posted by	Spddracer on April 28, 2008 at 7:35 PM
	This message has been viewed 149 times.
In Reply To	Worn CAS and cam? posted by let's go A's on April 28, 2008 at 04:53 PM
Message	The cam will look almost like shark fins instead of a a sqaure cut tooth pattern. There is usually rust on both the cam and CAS. Replacing the Cam and Cas should sure you problem. Timing usually jumps around like crazy when you watch them with a T light if they are worn. Causes crazy hesitations ect. I never heard of the alignment issue in the head and cam before thou. I replaced a few cams in the early cars and Tech line never mentioned this to me. If there is a TSB floating around I have never seen it. I assumed the ware was from water and rust. I can look it up tomorrrow at work if I have time and see. I would suck monkey balls to get my Z black... (n/m) - scottyfender 02/22/08 23:14:01
Follow Ups	Worn CAS and cam? - let's go A's 16:53:55 04/28/08 What have you tried? - Noncon 17:22:58 04/28/08 i did test the tps a while ago - let's go A's 18:09:27 04/28/08 I have seen this a few times. - Spddracer 19:35:14 04/28/08 "is it a 90" at the bottom of this page - let's go A's 20:06:44 04/28/08 I have all the TSB indexes for the last 20 years :) - Spddracer 20:16:36 04/28/08 207,500 miles (n/m) - let's go A's 22:04:37 04/28/08 Re: Worn CAS and cam? - sandmanz32 20:07:56 04/28/08 i got a cas you can have for $75 shipped (n/m) - pearlyellowtt 20:33:33 04/28/08 I had the same problem a few years back. The half - RHulme 22:10:57 04/28/08 weird, i have a 90 that was made in 3/89 and stills - ghostinator (fl) 23:21:24 04/28/08 I had the same problem with a 6/89 motor - spyhunterTT + 93Vert(nj) 16:57:05 04/29/08 did you replace the cam shaft also? (n/m) - let's go A's 22:27:31 04/29/08
Post a Followup	You cannot reply to this message because you are not logged in.