Subject	Re: I adjusted my parking brake at the rear wheel hubs -
Posted by	txq45 on April 28, 2008 at 7:23 PM
	This message has been viewed 152 times.
In Reply To	I adjusted my parking brake at the rear wheel hubs - posted by robo (sebring1970) on April 28, 2008 at 07:13 PM
Message	No they don't self adjust ... you pull the rubber plug out of the rotor housing and loosen or tighten via screw driver or brake tool.. Not that important as long as your brake holds and its at the right height..
Follow Ups	I adjusted my parking brake at the rear wheel hubs - - robo (sebring1970) 19:13:00 04/28/08 Re: I adjusted my parking brake at the rear wheel hubs - - txq45 19:23:12 04/28/08 not what I meant. I already did that. It's hard to 'splain - robo (sebring1970) 19:51:32 04/28/08 See page 24 in the FSM/ Brakes. Says to adjust - Audioquest 20:37:33 04/28/08 yeah, I got to that point too. The problem is, turning - robo (sebring1970) 21:04:40 04/28/08 I doubt it matters that much as cable E-brakes tend to - Audioquest 22:20:59 04/28/08 that's what I am talkin' about (n/m) - robo (sebring1970) 08:20:03 04/29/08 Will one rear wheel turn by hand while jacked in the air - robo (sebring1970) 21:06:37 04/28/08 Not easily. (n/m) - Spddracer 21:17:04 04/28/08 Would you say that it is too hard to be able to turn a - robo (sebring1970) 21:35:32 04/28/08 FYI -- I've always been able to turn one wheel if the other - jzack 22:45:10 04/28/08 Thanks everyone. Here is the end result of all those Q's. - robo (sebring1970) 13:35:05 04/29/08
Post a Followup	You cannot reply to this message because you are not logged in.