Subject	for a stuck injector screw, I use a needle nose vise-grip
Posted by	Guapo on April 24, 2008 at 10:07 PM
	This message has been viewed 198 times.
In Reply To	Injector Clamp Stuck posted by Z-stafa (Mesa, AZ) on April 24, 2008 at 09:47 PM
Message	along with the screwdriver. Turn both slowly at the same time, and I've never had one fail to break loose. Petz #2 "What's the point of having the car if you don't drive it?" - Mrs. Guapo 08/20/05 Jeeeesus Christ - my Dad (after a ride in my Z) 12/26/04 People have the right to freedom of expression. However, people also have the right to point and laugh- aliaZ 04/06/06
Follow Ups	Injector Clamp Stuck - Z-stafa (Mesa, AZ) 21:47:28 04/24/08 for a stuck injector screw, I use a needle nose vise-grip - Guapo 22:07:39 04/24/08 2nd, worked every time (n/m) - robo (sebring1970) 23:05:23 04/24/08 2nd - great tool for this. Home Depot and ACE have small - jzack 23:05:46 04/24/08 2nd Then get rid of the screws and replace with allen heads (n/m) - Piranha(AZ) 23:29:06 04/24/08 Not to the best idea -- issues with clearance and hard - jzack 00:08:05 04/25/08 I usually agree w/ your advice, but have to 2nd Piranha on - ThunderZ 06:33:20 04/25/08 The clearance issue is basically my gripe -- bad enough - jzack 19:48:01 04/25/08 And a valid concern- the allen head is much higher. - ThunderZ 22:04:17 04/25/08 I have found that removing the plenum takes care of - Piranha(AZ) 02:31:28 04/26/08 My new plenum is chrome - that's the only way I'm going - jzack 08:33:19 04/26/08 Actually, they are easier to remove and install - Guapo 08:52:26 04/25/08 5th. (n/m) - Woody75 (Denver) 12:04:02 04/25/08 yup, Allens > Phillips (n/m) - robo (sebring1970) 14:36:59 04/25/08
Post a Followup	You cannot reply to this message because you are not logged in.